[MLB-WIRELESS] hops over water

Jason Tedesco jtedesco at request.com.au
Fri May 30 15:05:25 EST 2003


Matt,    
    Sorry to say I have no idea how long the point to point link is over the water.  I should so some research, and check an on-line map.  I think it will be approx 10 to 20km's.
 
# jason

-----Original Message-----
From: Matthew Hill [mailto:matthew.hill at matthewhillonline.com]
Sent: Thursday, 29 May 2003 12:07
To: Melbourne Wireless
Subject: Re: [MLB-WIRELESS] hops over water


Jason
 
how far in distance was the link...
 
Matt

----- Original Message ----- 
From: Jason  <mailto:jtedesco at request.com.au> Tedesco 
To: Glenn Cook <mailto:agmcom at bigpond.com>  ; melbwireless at wireless.org.au ; Clae <file://clae@tpg.com.au>  
Sent: Thursday, May 29, 2003 11:34 AM
Subject: RE: [MLB-WIRELESS] hops over water

I did have a link going over water from Werribee South to Port Arlington.  The equipment used was two 25db grids at each end.  Looking at net stumbler the link was relatively strong.  

Although throughput of data was dreadful, although I think this was due to the hop I was routed to.

I've currently just removed my AP from my mast, and am installing a Linux box in my roof, so I can let you know how the signal is once everything is set up again.


Link below of view across the bay.
http://www.jason.id.au/wifi/slides/DV00026.html

> -----Original Message-----
> From: Glenn Cook [mailto:agmcom at bigpond.com]
> Sent: Wednesday, 28 May 2003 20:14
> To: melbwireless at wireless.org.au; Clae
> Subject: Re: [MLB-WIRELESS] hops over water
> 
> 
> I installed a radio link between Bourke Place and Woolstores 
> (Geelong) for
> Deakin Uni a few years ago.
> 
> It was a 7 Ghz, 34 Mbps space diversity link.
> 
> And yes, water can be an absolute pain to get a link over.
> 
> Glenn
> 
> ----- Original Message -----
> From: "Clae" < clae at tpg.com.au>
> To: < melbwireless at wireless.org.au>
> Sent: Tuesday, May 27, 2003 6:10 AM
> Subject: [MLB-WIRELESS] hops over water
> 
> 
> From the wireless-longhaul list.
> 
> The idea of links over water has been discussed previously on MW to
> link areas surrounding Port Phillip Bay.  I believe there is one such
> link functioning in the Williamstown area.
> 
> The following discussion covers technical aspects of these links,
> problems encountered, and how to get the best results, from people
> who have actually done this.
> 
> Clae.
> 
> /some snipping for brevity/
> 
> >Date: Sun, 25 May 2003 16:11:22 -0700
> >From: Tim Pozar < pozar at lns.com>
> >
> >On Sun, May 25, 2003 at 07:06:18PM -0400, S Woodside wrote:
> >>  On Saturday, May 24, 2003, at 11:45  PM, Ben Johns wrote:
> >>  > Has anyone on the list done something similar? I'm 
> interested to know
> >>  > how
> >>  > ocean/sea could affect a signal. The water is pretty 
> calm most of the
> >>  > time, sheltered by the islands/reefs, but could 
> reflection/refraction
> >>  > still have an effect?
> >>  >
> >>  I remember reading about a link over water, at a nature preserve I
> >>  think over a lake. IIRC the polarization made a difference, don't
> >>  remember which way was better though.
> >
> >You want to be vertically polarized to minimize the horizontal
> >polarized signals from the water.
> >
> >Tim
> >------------------------------
> >
> >Message: 3
> >Date: Sun, 25 May 2003 13:47:10 +0700
> >From: Stefan Probst < stefan.probst at opticom.v-nam.net>
> >
> >At 13:45 25.05.2003 +1000, you wrote:
> >-------------------------
> >  >Has anyone on the list done something similar?
> >
> >I was line-up engineer for a 4.7 GHz radio link over wet 
> (wet rice fields)
> >and water terrain.
> >
> >The problem is, that you are very likely to get reflection 
> from the water
> >and from air layers of different humidity above the water, caused by
> >temperature differences. The result is, that you get at the 
> receiving side
> >not only the direct signal, but also the reflected one. The 
> reflected one
> >has to travel a longer distance and is therefore delayed, i.e. phase
> >shifted, with the original at the receiving antenna. Depending on the
> >distance, the phases will be in sync, i.e. the signal gets 
> stronger. If it
> >is 180f out of sync, the both signals will be subtracted, 
> i.e. get much
> >weaker, or can even disappear. Since this is not a constant, 
> and not a
> >single reflection, the result is, that the signal strength 
> fluctuates. The
> >result is known as "fading".
> >
> >Solutions:
> >- Very, very highly directional antennas that shield the 
> reflected signal.
> >    Usually only feasible over short links and high towers, 
> i.e. if there
> is
> >    a sufficient large angle between the direct and the 
> reflected signal.
> >- If you are lucky, you can chose a signal path that has a natural
> obstacle,
> >    like a mountain, in such a way that it shields the reflected
> >signal from the
> >    receiving antenna.
> >- Frequency Diversity: Since the phase difference depends on 
> the frequency,
> >    there are good chances, that in case the resulting 
> receive level on one
> >frequency
> >    is different from another frequency.
> >    Means: The signal is transmitted simultaneously on two different
> >frequencies.
> >    When the bit error rate exceeds a certain level on the 
> receiving side,
> the
> >    receiver would quickly switch over and take the signal 
> from the other
> >    frequency.
> >- Space Diversity: The signal is received by two antennas, 
> that are mounted
> >    with a certain distance above each other.
> >    The reflected signal changes at the two antennas, it 
> will sometimes add
> >    "in phase", sometimes completely "out of phase", i.e. 
> cancelling the
> direct
> >    signal. By choosing an appropriate distance (there are 
> some ways to
> >determine
> >    it), it is possible to minimize the likelihood, that there is a
> >cancellation
> >    at both antennas at the same time. The receiver will 
> choose the antenna
> >    with the best signal. (Well, in fact there are two receivers and
> >a circuitry
> >    determines which signal to choose).
> >    Space diversity if often also used with wireless 
> microphones, high
> quality
> >    cordless phones, WiFi base stations.
> >    As a modification (or in addition), you can save the second
> >receiver and the
> >    switch-over circuitry by combining the signal of both 
> antennas in such
> a
> >way,
> >    that the direct signal is "in phase".
> >    This means usually to add some extra RF cable length to the lower
> antenna,
> >    so that both cables are same long. By this, the direct 
> signal adds
> always
> >    correctly. The reflected signal will be different, and sometimes
> >"in phase",
> >    sometimes "out of phase". Only if it is "out of phase" 
> at both antennas
> >    would the signal be completely lost. You should be able 
> to increase the
> >    effect by creating an array of several antennas above each other.
> >In reality, Space and Frequency Diversion is often used at 
> the same time.
> >
> >Good Luck!
> >
> >Stefan
> >
> >
> >------------------------------
> >
> >Message: 4
> >Date: Mon, 26 May 2003 10:39:34 +1000 (EST)
> >From: "Ben Johns" < benj at marinanet.com.au>
> >
> >As Stefan Probst has recommended, I will be using two 
> antennae on each end
> >of a link for space diversity. Although I would like to know 
> if having the
> >two antennae set to different polarizations is of any 
> benefit. Ie, have
> >one set to horizontal and the other to vertical. Or should I 
> just have
> >them both set to vertical?
> >
> >--
> >Regards,
> >
> >Ben Johns
> >
> >------------------------------
> >
> >Message: 5
> >Date: Sun, 25 May 2003 18:22:05 -0700
> >From: constantinos at shaw.ca
> >
> >We have a 23 mile link going over a strait of ocean.  As long as you
> >have enough power, your high enough so the fresnel zone is clear,
> >good LOS, you should be good to go.
> >
> >Cheers,
> >
> >Constantinos Tsakonas
> >www.constantinos.ca
> >
> >------------------------------
> >
> >Message: 6
> >Date: Mon, 26 May 2003 08:44:51 +0700
> >From: Stefan Probst < stefan.probst at opticom.v-nam.net>
> >
> >At 10:39 26.05.2003 +1000, you wrote:
> >-------------------------
> >>As Stefan Probst has recommended, I will be using two 
> antennae on each end
> >>of a link for space diversity. Although I would like to 
> know if having the
> >>two antennae set to different polarizations is of any 
> benefit. Ie, have
> >>one set to horizontal and the other to vertical. Or should 
> I just have
> >>them both set to vertical?
> >
> >My tip:
> >Try, try, try.
> >Usually, it should both be vertical. But there are sometimes 
> crazy effects.
> >
> >I would even start with one antenna. Maybe it is enough. I 
> guess that in
> >colder climate fading over water is not such a problem like 
> in tropical and
> >subtropical areas like here.
> >If one antenna is not enough, try the second one and observe the
> difference.
> >Maybe you find somewhere on the Web a way on how to 
> determine the best
> >height difference.
> >
> >And be prepared that things change over time, with seasonal 
> changes of the
> >weather.
> >
> >Also, the thing with the two "electrically same long" 
> antenna cables sounds
> >a bit easier than it is. Depending on the type of antenna 
> mast etc., the
> >lower antenna (where the mast is often thicker) might be 
> some cm "closer"
> >to the sending antenna. The result was, that I usually had 
> to find the
> >right additional cable length empirically, i.e. try 
> different additions and
> >observe the level of the received signal. This can be done 
> of course only
> >during daytimes with little fading....
> >
> >Good Luck!
> >
> >Stefan
> >
> >------------------------------
> >
> >Message: 8
> >Date: Sun, 25 May 2003 18:17:45 -0700 (PDT)
> >From: Michael Przybylski < mikep at core.ucsd.edu>
> >
> >Another standard trick I have heard of to minimize reflections with
> >over-water links is positioning one antenna high, the other one low.
> >
> >Regards,
> >Mike Przybylski
> >
> 
> --
> "Our earth is degenerate in these latter days; bribery and corruption
> are common; children no longer obey their parents; and the end of the
> world is evidently approaching." -- Assyrian clay tablet 2800 B.C.
> 
> To unsubscribe: send mail to majordomo at wireless.org.au
> with "unsubscribe melbwireless" in the body of the message
> 
> 
> To unsubscribe: send mail to majordomo at wireless.org.au
> with "unsubscribe melbwireless" in the body of the message
> 
> 

To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.wireless.org.au/pipermail/melbwireless/attachments/20030530/4dc5f6b5/attachment.html>


More information about the Melbwireless mailing list