[MLB-WIRELESS] GDW -> GHO

[Richard Van Orsouw]

ok, sounds like a plan, will give it a go ( once gho is back on-line )

Thanx

> ----------
> From: 	Rowan Crowe
> Sent: 	Tuesday, 10 June 2003 4:22 PM
> To: 	melbwireless at wireless.org.au
> Subject: 	RE: [MLB-WIRELESS] GDW -> GHO
> 
> On Tue, 10 Jun 2003, Richard Van Orsouw wrote:
> 
> > Ok, must have something to do with sliding windows, and 3 way
> handshakes,
> > must try adjusting ttl timers and the like.
> 
> TCP is fairly robust unless there is a lot of packet loss. I don't think
> latency is your problem, TCP can still push through data at a reasonably
> consistent rate even if it's through an overloaded 56k modem @4000ms
> latency.
> 
> Try something like...
> 
> ping -c 200 -f -s 1460 <destination>
> 
> This will flood 200 packets of size 1460 bytes (plus IP+ICMP header) as
> fast as possible to the other end. Over a wired LAN, there should be 0%
> packet loss. I'm not sure what a typical result would be for a wireless
> connection, but if you have more than about 5-10% loss then TCP will start
> stalling and misbehaving...
> 
> Cheers.
> 
> 
> --
> Rowan Crowe - Melbourne, Australia
> www.camrecord.com  www.camdiscover.com  www.heyasl.com
> www.sensationbot.com
> 
> 
> To unsubscribe: send mail to majordomo at wireless.org.au
> with "unsubscribe melbwireless" in the body of the message
> 
> 

To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message