[MLB-WIRELESS] replacement for a dlink900+

[David Ng]

I assume 10.10.144.130 is the eth address of the AP?

Yeah I get that problem sometimes.  Are you running in bridge mode or
AP/client mode?
I find that when the AP is busy processing or forwarding something, it hangs
momentiarly (ie stops responding), so the eth pings dont get replied by the
AP.  It also happens when the tx rates are set too high (maybe the AP is
trying to step down to a lower speed), try lowering them.

I've had lots of little problems with the 900AP+, running two units in
AP/client mode causes all sorts of headaches like dropouts, etc, but running
them back to back in brg mode seems ok.

Regards,
David

----- Original Message -----
From: "rick" <mibz at optushome.com.au>
To: "Melb Wireless" <melbwireless at wireless.org.au>
Sent: Wednesday, July 16, 2003 11:54 PM
Subject: [MLB-WIRELESS] replacement for a dlink900+


> i seam to be having alot of problems with my dlink900+ im after something
i
> can have full control thru a web interface like the dlink900+ it doesnt
have
> to be 22mb
>
> there is NOTHING wrong with the wireless side only with the eth side where
> im getting alot of loss
>
> any ideas (see below for pings)
>
> Pinging 10.10.144.130 with 32 bytes of data:
>
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Request timed out.
> Request timed out.
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Request timed out.
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Request timed out.
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
> Reply from 10.10.144.130: bytes=32 time<1ms TTL=127
>
> Ping statistics for 10.10.144.130:
>     Packets: Sent = 14, Received = 10, Lost = 4 (28% loss),
> Approximate round trip times in milli-seconds:
>     Minimum = 0ms, Maximum = 0ms, Average = 0ms
> Control-C
> ^C
> C:\Documents and Settings\rik>
>
>
>
> To unsubscribe: send mail to majordomo at wireless.org.au
> with "unsubscribe melbwireless" in the body of the message
>
>


To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message