[MLB-WIRELESS] Tools for Dlink 900AP owners

[Justin]

Hey Darren,

 Thanks for the info, this is just what I needed. Too hot outside so I
thought I'd hack the new AP :)

 I think I've done something bad though.... :(

Regards,
Gaz.




  -----Original Message-----
  From: owner-melbwireless at wireless.org.au
[mailto:owner-melbwireless at wireless.org.au]On Behalf Of
darrend at ndpgroup.com.au
  Sent: Saturday, 25 January 2003 1:03 PM
  To: melbwireless at wireless.org.au
  Subject: [MLB-WIRELESS] Tools for Dlink 900AP owners



  For those who have some of these as I do, here are some links that may be
of interest.

  Firstly, you can get the 1.4j1 firmware from this page.
  http://www.seattlewireless.net/index.cgi/Wap11Hack
  Also the atmel snmp config utility which will allow you to adjust the
output power. (see instructions on that page)

  Also, the linksys wap11 USB config allows for individual tx and rx
diversity setting which is handy if you intend to mast mount one of these
babies!
  ftp://ftp.linksys.com/pub/network/wap11sw.exe
  These are much nicer config tools to use than the dlink versions!

  FYI, the RP-SMA is attached to the 'Left' output.

  Darren Dreis
  Vice President
  Melbourne Wireless Inc.
  vicepresident at wireless.org.au
  http://www.wireless.org.au
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.wireless.org.au/pipermail/melbwireless/attachments/20030125/13202628/attachment.html>