[MLB-WIRELESS] GDW -> GHO

Jamie Moir jmoir at jmcs.net.au
Tue Jun 10 10:35:19 EST 2003


On Tue, 10 Jun 2003, Richard Van Orsouw wrote:

> I am either going to replace the entrasys card with a veritech 200mW or I
> have a Cisco AP1200 which I might run in client AP mode. Does any know where
> I can get a pigtail for it, I believe it uses a RF-TNC ?

I have reverse gender TNC pigtails for $27 if you dont get a local source.

> was also suggested trying mtu/ttl values. This problem I am experiencing is
> most likely due to the poor rx from gdw to gho, but it also could be a
> timing issue due to the long round trip delays ( since my link is 64km plus
> another 20km to the other nodes). Any suggestions on values I could try
> would be appreciated.

64km is really an impressive link, I think Perth is largely too flat for
that =)

Jamie


To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message



More information about the Melbwireless mailing list