[MLB-WIRELESS] Mounting weatherproof AP box

[Peter Buncle]

Hi,

You could try
making a piece of Perspex longer than
the box top & bottom so you have some overhang
to drill holes for ubolt clamps.

You may find there are small 3mm holes 
in the back of the box. If so, 
drill holes in the perplex 
to accommodate the screws.


Or you could try making the Perspex plate,
then generously silicon the plate to the back of the 
box and let it cure completely undisturbed.



Cheers

Peter 



-----Original Message-----
From: emdeex [mailto:emdeex at gmail.com]
Sent: Friday, 8 September 2006 12:52 PM
To: melbwireless at wireless.org.au
Subject: [MLB-WIRELESS] Mounting weatherproof AP box


Hi all,

Ive got a Senao AP and a weatherproof box for it.  How should I
actually mount the box on the antenna mast?  The box doesnt have any
obvious mounting points.  I'm thinking of making some small holes in
it to thread some long zip-locks through and then around the mast and
tightening it onto the mast.

Any one with experience with weatherproof boxes like this?

Its sort of like one of these boxes :
http://www.gatewayelex.com/abswxprf.htm
_______________________________________________
Melbwireless mailing list
Melbwireless at wireless.org.au
http://wireless.org.au/mailman/listinfo/melbwireless
-- 
Message protected by MailGuard: e-mail anti-virus, anti-spam and content
filtering.
http://www.mailguard.com.au/mg



-- 
Message protected by MailGuard: e-mail anti-virus, anti-spam and content filtering.
http://www.mailguard.com.au/mg