[MLB-WIRELESS] Swapping the broadcom radio for an atheros card inan R100

[Peter Buncle]

The senao 400mw wont work with the openwrt drivers YET as it's the new
generation card.

But the ubiquti 400mw card does work from a driver perspective, but I'm
not sure about the power 
Requirements side....

Peter


-----Original Message-----
From: lukebaldan [mailto:ljb2005 at iprimus.com-dot-au.no-spam.invalid] 
Sent: Thursday, 21 December 2006 4:01 PM
To: melbwireless at wireless.org.au
Subject: [MLB-WIRELESS] Swapping the broadcom radio for an atheros card
inan R100

Hi guys, i've got two AP's running on the melbournewireless network.
One of them is connected to a 9db omni for public access
(http://10.10.130.50 if you're on the network, http://baldan.dyndns.org
if you are not). I am wanting to swap out the broadcom radio for an
atheros card which are known to perform far better tha the broadcom,
there's a 400mw card available which would be perfect for my needs. I'm
runnin a mitsubishi R100 with a mini pci slot so the physical change
isn't much of a hassle, however in terms of software, what am i going to
need? I'm currently running openwrt rc6, i know i'll need madwifi
drivers, but what sort of configuration is involved? Thanks for any
help, Luke

_______________________________________________
Melbwireless mailing list
Melbwireless at wireless.org.au
http://wireless.org.au/mailman/listinfo/melbwireless
--
Message protected by MailGuard: e-mail anti-virus, anti-spam and content
filtering.
http://www.mailguard.com.au/mg





-- 
Message protected by MailGuard: e-mail anti-virus, anti-spam and content filtering.
http://www.mailguard.com.au/mg