[MLB-WIRELESS] GDW -> GHO

[Ben Holko]

UDP is transport also

IP is layer 3



-----Original Message-----
From: owner-melbwireless at wireless.org.au
[mailto:owner-melbwireless at wireless.org.au]On Behalf Of Richard Van
Orsouw
Sent: Tuesday, June 10, 2003 1:58 PM
To: 'melbwireless at wireless.org.au'
Subject: RE: [MLB-WIRELESS] GDW -> GHO


51.9km's to be exact!!,
thanx Jamie, I will try austwireless, but failing that I will give u a call.

btw, wrt the OSI model, my link seems to be working upto Layer 3, Layer 4 (
Transport, tcp ) is having issues, since picophone works fine (udp) to prove
this, can someone on GHO  run a TFTP server which uses udp so I can use it
to measure the bandwidth.

Cheers.



> ----------
> From: 	Richard Van Orsouw
> Sent: 	Tuesday, 10 June 2003 1:08 PM
> To: 	'melbwireless at wireless.org.au'
> Subject: 	RE: [MLB-WIRELESS] GDW -> GHO
>
> Too bad you couldn't send me a veritech on wednesday's order to melbourne
> :)
>
>
> > ----------
> > From: 	Jamie Moir
> > Sent: 	Tuesday, 10 June 2003 10:35 AM
> > Cc: 	'melbwireless at wireless.org.au'
> > Subject: 	Re: [MLB-WIRELESS] GDW -> GHO
> >
> >
> > On Tue, 10 Jun 2003, Richard Van Orsouw wrote:
> >
> > > I am either going to replace the entrasys card with a veritech 200mW
> or
> > I
> > > have a Cisco AP1200 which I might run in client AP mode. Does any know
> > where
> > > I can get a pigtail for it, I believe it uses a RF-TNC ?
> >
> > I have reverse gender TNC pigtails for $27 if you dont get a local
> source.
> >
> > > was also suggested trying mtu/ttl values. This problem I am
> experiencing
> > is
> > > most likely due to the poor rx from gdw to gho, but it also could be a
> > > timing issue due to the long round trip delays ( since my link is 64km
> > plus
> > > another 20km to the other nodes). Any suggestions on values I could
> try
> > > would be appreciated.
> >
> > 64km is really an impressive link, I think Perth is largely too flat for
> > that =)
> >
> > Jamie
> >
> >
> > To unsubscribe: send mail to majordomo at wireless.org.au
> > with "unsubscribe melbwireless" in the body of the message
> >
> >
>
> To unsubscribe: send mail to majordomo at wireless.org.au
> with "unsubscribe melbwireless" in the body of the message
>
>

To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message




To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message